Filter
Top Products
Child lock for the oven
To prevent children from switching on the
oven, it is possible to lock the oven controls.
1.
Turn off the oven by pressing button
.
2. Press Oven function and “
“ buttons at
the same time for about 3 seconds. An
acoustic signal will be emitted and the
indication ‘ SAFE ’ will appear in the
display
3. The oven is now locked. Neither oven
functions nor temperatures can be
selected.
To unlock the oven:
Press Oven function and “ ” buttons at the
same time and keep them pressed for about
3 seconds.
An acoustic signal will be emitted and the
indication “SAFE” will go out.
The oven can now be operated.
Fast heat-up function
After a cooking function and the temperature
have been selected, the cavity will gradually
heat up until the selected temperature is
reached.
This will take from 10 to 15 minutes,
depending on the selected function and
temperature.
If it is necessary to reach the required
temperature in a shorter time, the “Fast Heat
Up” function can be used.
1. Switch the oven on by pressing button
.
2. Set the required cooking function and
temperature as explained in the previous
pages.
3. Set the temperature by pressing button
“
" or “ ”. The temperature will
appear in the display.
4. Press the button Fast heat up. The
temperature display will show “ FHU ”
5. Press the button Oven function. The
symbol “ ° ” will flash for approximately 10
seconds. Now it is possible to select the
required temperature. To do this, press
the button “
” or “ ”.
6. When the required temperature is
reached, the electronic control beeps for
a short time, and the temperature display
reverts to the selected temperature.
This function can be used with any cooking
function or temperature.
Demo mode
This mode is intended to be used in shops to
demonstrate the oven functionality without
any power consumption except the interior
light, the display and the fan.
This function can only be switched on when
the appliance is first connected.
If there is a power failure, when the power
supply is restored again the Demo function
can only be switched on if, in the display, 12:00
and the symbol
are flashing automatically.
12