Filter
Top Products
Fault code and malfunction Possible cause and solution
•
appears in the digital display
• Intermittent audible signal
• Point-shaped optical signal is flashing
Anti-flood device is activated
• Close the water tap and contact our extended warranty
administrators, refer to Repairs-After Sales Service on the
following pages.
Malfunction Possible cause and solution
The programme does not start • The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel the delay
start.
Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the malfunction/fault code reappears or if
other fault codes not described in the charts
appear, please contact our extended
warranty administrators, refer to section
''Repairs - After Sales Service''.
The wash results are not satisfactory
The dishes are not clean
• The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water
reaching all parts of the surface. The baskets must not
be overloaded.
• The spray arms do not rotate freely due to incorrect
arrangement of the load.
• The filters in the base of the washing compartment are
dirty or incorrectly positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the
salt container is empty or the incorrect level of the water
softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet and dull
• Rinse aid was not used.
• The rinse aid dispenser is empty.
25