Filter
Top Products
Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing,and spot and streak free drying.
The dispenser, which is positioned inside the door, holds
about 110 ml of rinse aid, which is sufficient for 16 - 40
dishwashing programmes,depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full.The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the
next wash.
Only use branded rinse aid for dishwashers. Never fill
the rinse aid dispenser with any other substances
(e.g. dishwasher cleaning agent, liquid detergent).This
would damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector
(position 1 minimum dosage, position 6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there
are drops of water or lime
spots on the dishes after
washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the
control panel illuminates.
● If you are using dishwasher detergent that includes the
rinse aid function, it is necessary to deactivate the rinse aid
dispenser, in order to avoid a double dosage.
Deactivation/activation of the rinse
aid dispenser
(The dishwasher must be switched off)
Factory setting: rinse aid dispenser activated
When the rinse aid dispenser has been deactivated,
also the rinse aid indicator light on the control panel
is automatically deactivated.
1. Press the On/Off button.The On/Off indicator light
illuminates (setting mode).
I
f other indicator lights are on, this means that a wash
programme has been selected.The programme must be
cancelled: press simultaneously the function buttons 2 and 3
for about 2 seconds.All the indicator lights will turn off (except
for the On/Off indicator light and eventually salt and rinse aid
indicator lights) indicating that the set programme has been
cancelled and the machine is now in setting mode.
2. Press simultaneously function buttons 2 and 3, until the
indicator lights of the function buttons 1, 2 and 3 start
flashing.
3. Press the function button 2,the indicator lights of
function buttons 1 and 3 turn off while the indicator light
of the function button 2 goes on flashing, the digital
display indicates the current setting.
4. To change the setting, press the function button 2 again,
the digital display indicates the new setting.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button or wait about 60 seconds
after which the dishwasher will automatically return to
setting mode.
9
Rinse aid dispenser deactivated
Rinse aid dispenser activated (factory setting)