Filter
Top Products
Water hardness
Adjusting the water hardness
setting
Use of salt
Clarke °TH mmol/l manually electronically
< 5 < 7 < 0,7 1 level 1 no
Setting the water
softener
The water softener must be set in two ways:
manually, using the water hardness dial and
electronically.
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to position 1
or 2 (see table above).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level
5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights Glass,
Rinse hold and Multi tab start flashing.
3.
Press function button A, the lights of
function buttons Rinse hold and Multi
tab turn off while the light of function
button Glass continues to flash. The
current level shows on the digital display.
Examples:
displayed = level 5
displayed = level 10
4. To change the level, press function button
A. Each time the button is pressed the
level changes. (For the selection of the
new level see the chart).
Examples:
If the current level is 5, by pressing
function button A once, level 6 is selected,
if the current level is 10, by pressing
function button A once, level 1 is selected.
5. To memorise the operation, switch off the
dishwasher by pressing the On/Off
button.
12