Filter
Top Products
The water pressure must be within the limits
given in the "Technical data". Your local
Water Authority will advise you on the
average mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The dishwasher features fill and drain hoses
which can be turned either to the left or the
right to suit the installation by means of the
locknut. The locknut must be correctly
fitted to avoid water leaks. (Attention!
NOT all models of dishwashers have fill and
drain hoses provided with a locknut.)
If the machine is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few
minutes before connecting the inlet hose.
DO NOT use connection hoses which
have previously been used on an old
appliance.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.
Water inlet hose with
safety valve
After connecting the double-walled water
inlet hose, the safety valve is next to the tap.
Therefore the water inlet hose is only under
pressure while the water is running. If the
water inlet hose starts to leak during this
operation, the safety valve cuts off the running
water.
Please take care when installing the water inlet
hose:
• The electrical cable for the safety valve is in
the double-walled water inlet hose. Do not
immerse the water inlet hose or the safety
valve in water.
• If water inlet hose or the safety valve is
damaged, remove the mains plug
immediately.
• A water inlet hose with safety valve must
only be replaced by a local repair agent.
Warning! Dangerous voltage
Water outlet hose
connection
The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to the
underside of the work surface. This will
prevent waste water from the sink running
into the machine.
2. To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
The waste connection must be at a height of
between 30 cm (minimum) and 100 cm
(maximum) from the bottom of the
dishwasher.
30