Filter
Top Products
• Press the P-Button.
• Touch the right arrow until the display shows WATER PORTION.
• Place a cup or container underneath the frother (Fig. 15 ).
• Touch
ST@RT. The display shows PRESS KEY and the red
light in the Hot Water Button illuminates.
• Push the Hot Water Button. Hot water will be pumped through
the frother into the cup. The display reads
ENOUGH WATER?
PRESS KEY.
• When the desired amount of hot water is dispensed, push the
Hot Water Button to stop the flow. The amount of hot water in
your cup is now programmed. The display shows
WATER
PORTION
.
• Press the P button to return to SELECT PRODUCT.
Please note: When pumping hot water through the steam noz-
zle you can always stop the flow of hot water by simply pushing
the Hot Water Button. This will not change the programmed set-
ting. When the hot water output stops, you can dispense more
by pressing the Hot Water button again.
18g. SETTING THE TIME
You can enter the actual time into the machine. Once the time is
set you can then program the machine to turn on at a specific
time (next chapter).
Please note: The time is displayed in the 24 hr mode (not AM/PM).
If the actual time is 3:45 pm you must set the time to 15:45.
• Press the P-Button.
• Touch the right arrow until the display shows
TIME --:-- .
• Touch ST@RT. The hour segment starts blinking.
• Touch either arrow repeatedly to set the hours.
• Touch
ST@RT to confirm. The minute segment starts blinking.
• Touch either arrow repeatedly to set the minutes.
• Touch
ST@RT to confirm. Now the actual time is set.
• Press the P button to return to
SELECT PRODUCT.
Please note: The Impressa F9 will keep the time as long as the
machine is plugged in. If you unplug the machine or if you have
power interruption, the time will be lost.
18h. SETTING THE AUTO-ON TIME
You must first set the time (chapter above).
You can set the machine to turn on at a specific time. It will turn
on at that time, warm up and the display shows
PRESS MAINT.
Press the Rinse Button and you are ready to brew coffee.
• Press the P-Button.
• Touch the right arrow until the display shows
UNIT ON --:--.
• Touch ST@RT. The hour segment starts blinking.
• Touch either arrow repeatedly to set the hours.
• Touch
ST@RT to confirm. The minute segment starts blinking.
• Touch either arrow repeatedly to set the minutes.
• Touch ST@RT to confirm. Now the Auto Turn On time is set.
• Press the P button to return to SELECT PRODUCT.
18i. SETTING THE AUTO SHUT-OFF
Your F9 is programmed to turn off 2 hours after last use. Select
from
1
⁄2 hour to 9 hour shut-off or no automatic shut-off.
• Press the P-Button.
• Touch the right arrow, the display shows
OFF AFT. 2.0 HRS.
• Touch ST@RT.
• Touch either arrow repeatedly until desired setting is displayed.
• Touch
ST@RT to confirm.
20.