Filter
Top Products
– 11 –
Common Operations
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 15) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn 4 / ¢ to adjust the
hour, then press SET.
The minute digits start flashing on
the display.
• If you want to correct the hour after
pressing SET, press
CANCEL/DEMO.
The hour digits start flashing again.
3
Turn 4 / ¢ to adjust the minute, then
press SET.
DAILY
Canceled
ON TIME
(Daily timer setting)
ON TIME
(Recording
timer setting)
Clock
setting
(The hour digits
start flashing.)
REC
To check the clock time
Press and hold SET while playing any source.
• Pressing SET, the source indication appears again.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock
again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
On the unit ONLY:
When shipped, the unit is set to 9 kHz spacing.
You can only change the AM tuner interval spacing while
tuning into an AM station. (See page 15.)
Press STANDBY/ON while holding
down 7.
• Each time you press these buttons, the
AM tuner interval spacing alternates
between 9 kHz and 10 kHz.
STANDBY/ON
STANDB
Y
STANDBY/ON
STANDB
Y
STANDBY/ON
STANDB
Y
+
EN11-15.CA-MXDVB10,B9,A9_f 02.4.24, 9:41 AM11