Filter
Top Products
6 USK ICBM 30116/30155 - 090716
operation though, when the temperature in cavity will reach
above 5°C/ 40°F
CLEANING AND CARE
• If the compressor stops for any reason such as water shortage,
too much Ice, power off, etc... Do not start the system right
away, wait 3 minutes, and then re-start the Ice maker.
• Always add fresh water before starting ice production at initial
installation or after long shut off periods.
• To ensure the cleanliness of the ice cubes, water in the water
reservoir should be replaced every 24 hours
• Always unplug the appliance before cleaning it.
•
Clean the inner liner, ice collecting tray, water box, ice shovel
and evaporator frequently. Please do not use chemicals
improper for parts in contact with food. Rinse thoroughly before
starting the appliance again
.
• Wipe the appliance’s housing with kitchen paper or a soft damp
cloth.
• NEVER immerse the appliance in water or any other liquid.
• NEVER put any part of the appliance in the dishwasher.
• Do NOT use abrasive products.
• If you see a decrease in performance, limescale could be the
cause. Please use a solution with water and descaling agent
formulated for coffee makers (do NOT use vinegar). Start the ice
cube maker and let the solution run through for 5 minutes. Stop
the appliance for 5 minutes. Start the appliance again for 5
minutes and stop the appliance again. Remove all the solution
by using the drain plug at the back. Once done, rinse thoroughly,
repeating the whole operation twice or three times, this time with
clean water only. Do NOT consume the ice that might have been
done with the descaling solution.
• When you know that you will not use the appliance for a long
period, remove the drain plug and let the water come out of the
water tank. Screw the drain plug back in place after the water
has been drained.