Filter
Top Products
7 USK ICBM 30116/30155 - 090716
TROUBLESHOOTING
Problem Possible Cause Suggested Solutions
“Add water“ indicator
light is on, a long beep
sounds
There is no water Fill the water tank with water,
wait 3 minutes and press the
start button to restart.
“Ice Full“ indicator
light is on, a beep
sounds
The ice tank full
capacity is reached
Empty ice basket completely
or partially, wait 3 minutes and
press the start button to restart.
My Ice melts The compressor has
stopped automatically.
Restart the compressor by
pressing on start after the “Ice
Full” or “Add Water” have
been lit (see above).
Nevertheless, operation will
restart automatically once the
temperature in the cavity will
be above 40°F
Pilot lights do not turn
on
Blown fuse/ No power Check the power socket /
Have the fuse replaced by a
competent electrician. Please
use fuse value AC 250V, 3.15A,
∮5 x 20 only
The Ice made falls like
a single block, with a
lot of cubes sticking
together.
The water temperature
in the water storage
box or ambient is too
low
Stop the machine and reset
the ice making cycle. Restart
the machine after turning it off.
Conditions for ice
making cycles are right
but no ice is made.
Refrigerant might be
leaking / sealed system
is
blocked
Call 1-888-KALORIK for service
or email through
www.kalorik.com
The lights of ice full and
deficient come on in
the same time.
Water tray is blocked
by ice cube
Unplug the appliance.
Clean the evaporator.
Plug the appliance back in
and press the ”START” button.
The appliance will restart
automatically after 2 minutes.
The ice cube maker is
jammed, or the water
does not flow uniformly
in the evaporator
Water pipe is clogged
by limescale or other
particles
Please pull out the cap of the
water pipe, then let the water
through the pipe in order to
clean it and wash the clog
away, then replace the cap.
Resume operation.