Kalorik USK MCL 36711 Beverage Dispenser User Manual


 
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity. Print only what is inside the frame.
5 USK MCL 36711 - 110622
Assembly page 5/16
Fax +32 2 359 95 50
INSTALLATION
Position the appliance and allow it to stand for two or three hours
before turning it on for the first time, in order to allow the system to
settle. Do NOT position near to any heat source e.g. cooker, boiler or
direct sunlight etc.
A clearance of 5 inches must be left between the sides of the
appliance and any adjacent cabinets or walls to allow for adequate
air circulation. The appliance is not designed for recessed
installation, meaning it should NOT be built-in.
Install on a good firm level surface and any unevenness of the
surface should be corrected prior to installation.
VENTILATION
Please make sure this item is well ventilated and that the slots and
openings are not blocked to keep it from overheating.
CLEANING
Make sure to remove the machine from the wall plug before
cleaning and do not use abrasive cleaners. We suggest using a
damp cloth.
PLACEMENT
Do not put this item on an unstable area where it may fall. Its weight
is heavy enough that in event it does fall it can cause physical
damage.
CONDENSATION WATER REMOVAL
In all cooling appliances, condensation of water is a perfectly
normal process. Air humidity becomes water in reaction with the
colder temperature.
As a consequence, you may notice a pool of water at the bottom of
the appliance.
If this is the case, please slide out the bottom tray and dispose of the
water regularly.