Filter
Top Products
Using Your
Kambrook Aquarius Kettle
Before first use of your new Kambrook
Aquarius Kettle, clean the element and
internal section of the container by boiling
the kettle full, following the instructions
below, and then discard water.
NOTE:The Kambrook Aquarius Kettle (Model
KAK36) must only be used with the power base
supplied.
To fill the kettle, open the lid by pulling up
on the handle on the lid.
Fig 1
Do not fill above the max water level line
or below the minimum water level line
marked on the water window.
Do not overfill the kettle as this may
result in boiling water being splashed out
and too little water will result in the
kettle switching off before the water has
boiled.
Place the kettle (or cordless base and
kettle) on a level, flat surface. Ensure that
the lid is locked firmly in place and then
place the kettle securely onto the power
base (KAK36 only).
Connect power cable supplied to
appliance (KAK35 only).
Important: Make sure this plug is firmly
inserted into socket.
Connect 3 pin 230/240V plug to power
supply. Turn power on.
Push the On/Off switch up, located at the
base of the handle.The 'on' light will
illuminate indicating that the kettle is
boiling water. Once the water is boiled
the kettle will automatically switch off.
For KAK35 corded kettle, switch power
off at the power outlet and remove plug
from power point and then from kettle
before pouring water as required.
For KAK36 cordless kettle switch off at
the power outlet and then lift the kettle
from the power base and pour as
required using the handle.
Take care to hold the kettle level
especially when filled to the maximum
level.
Kettle can be returned to cordless base
when not in use.
Ensure that the power is switched of at
the po
w
er outlet when the kettle is not in
use.
NOTE: Use caution when pouring water from your
kettle, as boiling water will scald. Do not pour the
w
ater too quickly.
4