Kambrook KSK76 Hot Beverage Maker User Manual


 
9
Care, Cleaning and Storage
Always switch appliance OFF, then
switch off at the power outlet and
then unplug before cleaning
the appliance.
WARNING: Never
immerse the kettle base,
switch area, power base
or power supply cord in
water or allow moisture
to come in contact with
these parts.
Cleaning the Exterior
& Removable Filter
The exterior surface may be wiped
over with a damp cloth and polished
with a soft clean dry cloth.
NOTE: Do not use chemicals,
steel wool, or abrasive cleaners
to clean the outside of the kettle.
CAUTION: To prevent
damage to the
appliance do not
use alkaline cleaning
agents when cleaning;
use a soft cloth and
mild detergents.
The filter fitted inside the kettle over
the spout is removable by sliding in
and out of position. The filter can be
washed in warm, soapy water.
TIP: The filter could become
damaged with time, please
check regularly and replace if
found damaged.
NOTE: Ensure the kettle and
water have cooled down before
attempting to clean the filter.
Mineral Deposits and
Discolouration
Due to the large surface area of the
concealed element interior base,
discolouration due to mineral deposits
will appear more obvious. The mineral
deposits can leave a brown stain on
the base. THIS IS NOT RUST.
To remove the discolouration follow
the cleaning instructions “Removal of
Mineral Deposits”.
Removal of Mineral Deposits
Mineral deposits in tap water may
cause the kettle interior to discolour
over time.
This may be removed by using a kettle
descaler which is available from most
leading supermarkets, department
and hardware stores.
Alternatively: Fill the kettle with 3 cups
of white vinegar and the remainder
(up to
2
3 of maximum) with water, boil
and allow to stand overnight.
Empty the solution from the kettle.
Fill the kettle with clean water, bring
to the boil and discard the water.
Repeat and the kettle will be ready
for use.
Storage
Ensure the kettle is switched off,
cleaned and dried before storing.
Ensure that the lid is closed and
locked firmly into place. Wrap the
power cord around the cord storage
under the power base. Stand the
kettle upright on the power base. Do
not store anything on top.