Filter
Top Products
1
2
3
4
14
Battery Installation
H
Important Note: Use only a Power Wheels
®
(4 Amp/hr.) battery with a Power Wheels
®
25 amp fuse installed. Use of any
other battery or fuse will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the
enclosed Power Wheels 6 Volt charger before operating your vehicle for the first time. Charge the battery for at least 18
hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions
may damage your battery and will void your warranty.
• If the seat is locked, use a slotted screwdriver to rotate
the lock fastener
1
/
4
turn to the unlocked position ( ).
• Lift the seat and remove it from the vehicle body.
Battery
• Place the Power Wheels
®
battery upright in the battery
compartment. Do not remove the battery from its
protective foam pocket. Make sure the battery
connector extends toward the rear of the vehicle.
• Make sure a Power Wheels
®
25 amp fuse in good
condition is installed in the battery.
Battery
Battery
Retainer
Battery
Connector
Motor
Harness
Connector
• Position the battery retainer over the battery with the
ends of the battery retainer aligned with the screw holes
in the vehicle body.
• Insert two #10 x
7
/
8
screws through the ends of the
battery retainer and into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Plug the battery connector into the motor harness
connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
• Re-assemble the seat to the vehicle body. (See assembly
steps 19 and 20 on page 13).
Important Note: Always remember to lock the lock fastener
to prevent children from accessing the battery.