Filter
Top Products
4
INSTALLING A
COOKING SHEET
1. Raise Top-Side
™
Cooking head completely.
2. Lay the 20'' x 24'' (508mm x 610mm) cooking sheet
o
n the griddle plate with 20'' (508mm) dimension
front to back.
3. Lower the Top-Side
™
Cooker head onto the
cooking sheet, ensuring that the sheet is centered
under the head, the front edge of the sheet is even
with the front edge of the head, and the sides of the
sheet are parallel to the side of the head.
4. Fold both edges of the cooking sheet over the
head. While gently pulling the right side of the
sheet to remove any slack, firmly push the cooking
sheet mounting clip onto the right side mounting rib
on top of the head.
5. Repeat process on the left side.
6. Reverse the process to remove the cooking sheet.
TIPS ON PROPER
HANDLING AND USE
OF COOKING SHEETS
To ensure long life of your Keating cooking sheets
please follow the tips below:
Cooking sheets should never:
Be folded or creased.
Be touched with sharp objects.
Come in contact with griddle scrapers or abrasive pads.
Be placed under other equipment or objects.
Cooking sheets should always:
Be wiped with a damp sof
t cotton cloth after each run
to remove any product residue.
Be cleaned after the griddle is shut down for the day.
The time to change a Cooking Sheet is when:
Product starts sticking to the sheet.
T
oo much carbon build-up causes a product
appearance, cooking or taste problem.
The head surface is cool.
The sheet is torn or ripped.
THE TOP-SIDE
™
COOKING HEAD AND GRIDDLE
PLATE ARE HOT - USE PROPER CARE WHEN
CHANGING THE COOKING SHEETS.
LEVELING OF
COOKING HEAD(S)
The cooking head(s) were leveled at the factory.
NOTE: For best results, level griddle before
checking. Adjust legs or stand casters to level griddle.
REMOVAL OF
COOKING HEAD
NOTE: To identify parts, refer to page 7.
1. Turn off griddle and disconnect Top-Side
™
Cooker
electric power.
2. Remove the cooking sheet by lifting off cooking
sheet mounting clips.
3. Place a layer of soft cloth and then a layer of
cardboard onto griddle plate under cooking head to
protect MIRACLEAN
®
surface.
4. Raise cooking head completely to release tension
on cooking head support pin. Remove support pin
and its cotter pin and carefully lower cooking head
to protected griddle surface.
The cooking head is not supported after the
cooking head support pin has been removed. If
dropped the weight of the cooking head when
unsupported will cause damage to the griddle
surface or injury to personnel.
5. Do not turn the support pin in either direction.
6. To reattach the cooking head to the ram lift arm,
raise cooking head completely and replace
cooking head support pin. Insert a new stainless
steel cotter pin to secure support pin, holding
support pin to keep it from spinning.
7. Replace cooking sheet. See - “Installing a Cooking
Sheet”.
WARNING
WARNING