Filter
Top Products
This Owner's Guide provides specific operating instructions for
your model. Use the refrigerator only as instructed in this
Owner's Guide. Before starting the refrigerator, follow these
important first steps.
iNSTALLATiON
,, Choose a place that is near a grounded electrical outlet. Do
Not use an extension cord or an adapter plug.
,, For the most efficient operation, the refrigerator should be
located where surrounding temperatures will not drop
below 40 ° F (5° C) or exceed 110° F (43° C).
,. Allow the following clearances for ease of installation,
proper air circulation, and electrical connections:
Sides 3/8"
Back & Top 1"
,, Do Not block the toe grille on the lower front of your
refrigerator. Sufficient air circulation is essential for the
proper operation of your refrigerator.
1" (25rnrn)
Refrigerator
/
Freezer
Installation
LEVEUNG
The refrigerator must have all bottom corners resting firmly on a
solid floor. The floor must be strong enough to support a fully
loaded refrigerator. NOTE: It is Very important for your
refrigerator to be level in order to function properly. If the
refrigerator is not leveled
during installation, the UnpackingandLeveEng
door may be misaligned
and not close or seal
properly, causing
cooling, frost, or moisture
problems.
LeveHr_g Feet
To Level Refrigerator:
Orating
After discarding crating
screws and wood base,
use a carpenter's level to
level the refrigerator from
front-to-back. Adjust the
plastic leveling feet in
front, Y2bubble higher, so 4_c,a_,,gS......
that the door closes A,,d_2)WoodB_s_,
--%
easily when left halfway
Unpacking and Leveling
open.
Leveling Instructions for all Refrigerator/Freezer Pair:
,, Remove two leg levelers provided in literature bag. While
unit is lying on its back for wood skid removal, install both
leg levelers in rear of unit.
,, Level door of first unit using all four levelers and slide unit
into place. Recheck for levelness and adjust if necessary.
. Measure distance from floor to bottom of door on first unit.
Adjust and level second unit so door height matches.
,, Leg Level Adjustments
,, One full turn of all four leg levelers will raise door 5/32".
,, One full turn
3/16" and tilt
,, One full turn
1/32" and tilt
,, One full turn
of both front leg levelers will raise door
top of door back 7/16".
of both rear leg levelers will lower door
top of door forward 7/16".
of both side leg levelers will raise door
3/16" and tilt top of door 3/8".
Slide second unit into place leaving a minimum gap of 3/16"
between units for door swing clearance.
This last step may require at least one extraction of the
second unit to properly align units in a "built-in" application.
DOOR OPENING
Shelf Front