Filter
Top Products
DOOR REMOVAL TO ADJUST CANTILEVER SHELVES
if door must be removed :
1. Gently lay refrigerator on its back, on a rug or blanket.
2. Remove two base screws and base panel.
3. Remove bottom hinge screws.
4. Remove plastic top hinge cover.
5. Remove screws from top hinge.
6. Remove top hinge from cabinet.
7. Remove door and bottom hinge from cabinet.
8. To replace door, reverse the above order and securely
tighten all screws to prevent hinge slippage.
Lift front edge up.
Pull shelf out.
Replace the shelf by
inserting the hooks at rear of
the shelf into the wall
bracket. Lower the shelf into
the desired slots and lock
into position.
COOL DOWN PERIOD
For safe food storage, allow 4 hours for the refrigerator to
cool down completely. The refrigerator will run continuously
for the first several hours.
TEMPERATURE CONTROL
The temperature control is located inside the refrigerator
compartment. The temperature is factory
preset to provide satisfactory food storage
temperatures. However, the temperature
control is adjustable to provide a range of
temperatures for your personal satisfaction.
If a colder temperature is desired, turn the
temperature control knob toward COLDEST
and allow several hours for temperatures to
stabilize between adjustments.
Cold Control
iNTERiOR LiGHTiNG
The lights comes on automatically when the door is opened. To
replace the light bulb, turn the temperature control to OFF and
unplug the electrical cord. Replace the old bulb with a bulb of
the same wattage.
ADJUSTABLE iNTERiOR
SHELVES
Multi-position adjustable interior
shelves can be moved to any
position for larger or smaller
packages. The shipping spacers
that stabilize the shelves for
shipping may be removed and
discarded.
Adjustable InteriorShelves - Upright Models
MiD LEVEL LiGHTiNG
The lights come on automatically when the door is opened.
To replace the light bulb, turn the temperature control to
OFF and unplug the electrical cord. Remove the lens
from the lamp housing by unsnapping it from the lamp
housing using your fingers or a screwdriver. Be careful not
to break the locking tabs on the lamp housing. Replace the
old bulb with a bulb of the same type and wattage. To
replace the lens, snap one side of the lens opening to the
tab on the lamp housing. Then carefully attach the other
side.
To Remove Light Lens _b,_,
PressTabs
in Direction Shown.
Mid Level Lighting
o/ \o
!o,
DOOR STORAGE
Door bins, shelves, and racks are provided for convenient
storage of jars, bottles, and cans. Frequently used items can be
quickly selected.
Some models have door racks or bins that can accommodate
gallon-sized plastic drink containers and economy-sized jars
and containers.
The dairy compartment, which is warmer than the general food
storage section, is intended for short term storage of cheese,
spreads, or butter.