Filter
Top Products
A: Usage Situations Where Appliance Power Cord
Will Be Disconnected Infrequently,
TEMPORARY METHOD
(Adapter plugs not
permitted in Canada)
Align large prongs/slots
Ensure proper ground
and firm connection
before use
An adapter may be used only on a 15_amp circuit.. Do not
use an adapter on a 20-amp circuit. Where local codes
permit, a TEMPORARY CONNECTION may be made to
a properly grounded two-prong wall receptacle by the use
of a UL-listed adapter, available at most hardware stores..
The larger slot in the adapter must be aligned with the
larger slot in the wall receptacle to provide proper polarity
in the connection of the power cord.
CAUTION: Attaching the adapter ground
terminal to the wall receptacle cover screw does not
ground the appliance unless the cover screw is metal,
and not insulated, and the wall receptacle is grounded
through the house wiring. The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is properly grounded.
When disconnecting the power cord from the adapter,
always hold the adapter with one hand.. If this is not done,
the adapter ground terminal is very likely to break with
repeated use° Should this happen, DO NOT USE the
appliance until a proper ground has again been
established..
B: Usage Situations Where Appliance Power Cord
Will Be Disconnected Frequently,
Do not use an adapter ptug in these situations because
disconnecting of the power cord places undue strain on
the adapter and leads to eventual failure of the adapter
ground terminal The customer should have the two-prong
walt receptacle replaced with a three-prong (grounding)
receptacle by a qualified electrician before using the
appliance..
The installation of appliances designed for mobile home
instaUation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and Set-Ups),
ANSI A22&1, latest edition, or with local codes.. In
Canada, mobile home installation must be in accordance
with the current CAN/CSA Z240/Mtl Mobile Home
Installation Code°
Electric Disconnect Plug
This plug allows you to conveniently disconnect the range
from electrical power.
1. Locate disconnect plug on the range back.
2. Pinch sides of connector and purl out of range back..
STEP 4
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
43