Kenmore 465.1334 Dishwasher User Manual


 
RECOM
Rinse Aid
important: This dishwasher is designed to use a
liquid rinse aid. Rinse aid greatly improves drying,
reduces spotting and filming, and reduces
moisture left on the dishwasher interior by
creating a "sheeting" action. Water "sheets" off
dishes, preventing drops of water from remaining
on dishes and creating spots. Drying performance
wilJ improve after several washes using rinse aid.
The automatic Rinse Aid dispenser _;,_ ,_, _ @
is located next to the detergent
cup. A pre-determined amount of
rinse aid will be added during the
final rinse. When the dispenser is
low and needs to be refilled, an
indicator light on the control panel
will illuminate.
Filling Rinse Aid dispenser:
1. Turn the plug 1/4 turn counterclockwise and remove.
2. Pour liquid rinse aid into the circular opening until
liquid reaches the FULL level marking.
3. Wipe up any rinse aid that spills into the dishwasher
with a damp cloth to prevent excess foaming.
4. Place the plug back into the Rinse Aid dispenser,
turning clockwise until the plug is secure.
Rinse Aid/Audible Feedback
Adjustment Mode
Important: The rinse aid/audible feedback mode
cannot be adjusted while a cycle is running, if the
Delay Hours option is running or if the dishwasher is
performing a Cancel/Drain.
To enter the rinse aid/audible feedback
adustment mode:
1. Press and hold the High Temp Wash option pad for
three seconds. An audible chime will sound to
indicate you have entered the rinse aid/audible
feedback adjustment mode.
2. The rinse aid has four levels, with "0" being the
lowest (no rinse aid being dispensed) and "3" the
highest. With each consecutive press of the
High Temp Wash option pad, the amount of rinse
aid dispensed into the dishwasher drawers will be
increased.
3. Cycle and option lights will illuminate with each
touch of the High Temp Wash option pad to indicate
the rinse aid level.
o OFF OFF OFF
1 ON OFF OFF
2 ON ON OFF
3 ON ON ON
Note: A Rinse Aid dispenser level of "0" disables i
1
the Rinse-Aid low indicator light.
4. To change the audible feedback, press the Delay
Hours option pad.
5. The first press of the Delay Hours option pad will
disable the drawer opened chime, the second press
will turn off the end-of-cycle chime. Each press will
toggle between the available settings. Delay Hours
lights will illuminate with each touch of the Delay
Hours pad to indicate the audible setting.
Drawer open/End=of=cycle 0 FF 0 FF
chime disabled
Drawer open chime enabled ON OFF
End=of=cycle chime enabled OFF ON
Drawer open/End=of=cycle 0 N 0 N
audio feedback enabled
6. Pressing any key pad other than High Temp Wash or
Delay Hours will exit the rinse aid/audible mode.
The rinse aid level and audible feedback selected will
be saved unless power is lost while adjusting the level.
If power is lost, the rinse aid level and audible
feedback will default to the last saved setting. Each
time the rinse aid/audible feedback adjustment mode
is entered the current setting will be recalled. The
rinse aid/audible feedback chime comes preset from
the manufacturer.
10