Filter
Top Products
CYCLES L|G
Delay Hours
The Delay Hours option can be used to
automatically start the cycle at a more convenient time
or to take advantage of reduced energy costs if
available in your area. This option is also useful for
conserving hot water at times of high household usage
(showers, laundry).
To set up a delay:
1. Select the desired cycle and options for the load.
2. Press the Delay Hours pad until the desired
amount of delay time is selected. There is a 2, 4 and
8 hour delay option. Continue pressing the Delay
Hours pad until you have made your selection.
3. As soon as the Start/Resume pad is pressed, the
delay time will begin counting down. When
counting down, the indicator light will change from
8Hr to 4Hr to 2Hr when the lower hour is reached.
4. The cycle will automatically start and the indicator
light will go out as soon as the delay time expires.
Notes:
• If 30 seconds elapse between setting the cycle
and options and pressing the Start/Resume or
Cancel/Drain pad, the dishwasher will turn off.
• Press the Start/Resume pad once, then close the
drawer. Drawer must be closed within 3 seconds
after pushing Start/Resume or the lights will flash
and the audio alarm sound will be heard.
To cancel a delay, press the Cancel/Drain pad once.
To cancel a running delay and start the cycle, press
the Delay Hours or Start/Resume pad.
indicator Lights on Outside of Drawer Dishwasher (select models)
The Washing cycle indicator light, located on the front of the drawer, will illuminate prior
to the first fill of any cycle. It will remain illuminated until the completion of the final
1) Washing drain. The washing indicator light will flash when the drawer is opened during the wash
portion of an operating cycle. If the drawer has been opened during a wash cycle,
Start/Resume will need to be pressed before the cycle will resume.
2) Drying The Drying indicator light, located on the front of the drawer, will remain lit until the
drying portion of the cycle is complete. If the drawer has been opened during a dry
cycle, Start/Resume will need to be pressed before the cycle will resume.
The Clean indicator light, located on the front of the drawer, will illuminate when the
3] Clean minimum dry time has been completed except when the Quick Rinse cycle is selected.
It will remain illuminated until the drawer is open for 30 seconds. If there has been a
power loss, the clean indicator light will not relight until after the next cycle is run.
13