Filter
Top Products
11
Care & Cleaning
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in burns.
Burn Hazard
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is usually
mounted on countertop and can be inspected by removing
the cover. This is not part of your dishwasher and is not
covered by warranty.
Outside—Occasionally wipe with a mild nonabrasive
detergent and water. Rinse and dry.
Inside—The inside of the dishwasher is self-cleaning with
normal use.
To clean Stainless Steel wipe with the grain.
NEVER use the products that contain Chlorine Bleach
or Citric Acid.
Important: The dishwasher motor is permanently
lubricated at the factory and does not need to be oiled.
TT
TT
T
o Disconnect Sero Disconnect Ser
o Disconnect Sero Disconnect Ser
o Disconnect Ser
vice:vice:
vice:vice:
vice:
1. Turn off electrical power to the dishwasher at the
supply source by removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water into
pan.
TT
TT
T
o Restore Sero Restore Ser
o Restore Sero Restore Ser
o Restore Ser
vice:vice:
vice:vice:
vice:
1. Reconnect the water, drain, and electrical power
supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher through a
NORMAL WASH Cycle.
4. Check connections to make sure they do not leak.
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
Winterizing
Note: Note:
Note: Note:
Note: See Installation Instructions for more details on
disconnecting and restoring service to your dishwasher.
Note: Note:
Note: Note:
Note: See Installation Instructions for more details on
disconnecting and restoring service to your dishwasher.