Kenmore 596.53463300 Refrigerator User Manual


 
fiYPBUTTOH(OHTROLFEATURES
0 0
<=>GOOD
O CHANGE
FILTER DISPENSER
DISPENSER
OPERATION
Todispense:
> SelectCUBE, CRUSHor WATER
modeby pushing buttonon dispenser
control panel.A green indicator light
abovebutton shows mode selection.
Presscontainer againstdispenser
pad.Selection mode may not be
changedwhile ice dispenser is in
operation,
NOTE: If waterdispenseris
continuouslyactivefor more than 5
minutes,an automatic lock out sensor
willshut down powerto dispenser area.
Forinstructions on howto unlock your
dispenser,see the section entitled
DispenserLock below.
DISPENSER LOCK
Thisfeature preventsice or
waterfrom being dispensed.
Tolock and unlock dispenser:
> Tolock dispenser,press and hold
LOCK/UNLOCKbutton for 3
seconds.A green indicator light
above button confirms dispenser is
locked.
> To unlock dispenser, hold
LOCK/UNLOCKbutton for 3
seconds. Green indicator light above
button will go out.
o o c)
FILTERED ICE & WATER
o
LIGHT
SENSOR
LIGHT
o
FILTER STATUS
INDICATOR LIGHT o°ooo
€_ CHANGE
The filter status indicator light
serves as a reminder to FILTER
replace the water filter.A green light
indicates that the filter is in good
condition. A red light indicates the filter
should be changed. Once light turns red,
it will remain red until function is reset.
To reset indicator:
> Press and hold both LOCK/UNLOCK
and WATER buttons simultaneously
for 4 seconds. The green filter status
indicator light will flash 3 times when
the function has successfully reset.
AUTO LIGHT
The auto light function
offers the ability to activate the
dispenser light at half-power when the
LIGHT SENSOR detects that the light
levels in room are low.
To activateand deactivate auto light:
To activate,press ON/OFF button
located on control panel. A green
indicator light above button displays
to show that sensor is active.
>- Todeactivate, press ON/OFF button.
Green indicator light will go out.
NOTE: Dispenser light will operate
whether or notauto light is selected.
SABBATH _+_
MODE
This mode is intendedto deactivate
power to the LED and dispenser lights,
while allowing the controls to remain
operational.
To activate and deactivate Sabbath
Mode:
Toactivate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneouslyfor 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will turn off.
Dispenser light will not activate
during dispensing while in this
mode.
Todeactivate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneouslyfor 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will
activate.
NOTE: In the event that power is
interrupted while the Sabbath Mode is
active, the control will remainin Sabbath
Modewhen power returns.
II'1
B
]9