Filter
Top Products
I SECTION2 HOW YOUR WATER FILTER WORKS
A. FACEPLATE TIMER FEATURES
The default settings for fill (6:00 minutes), brine
draw (80 minutes), backwash (12 minutes) and
fast rinse (8 minutes) cycles of regeneration are
factory set for maximum performance of the filter.
Use the following procedures to check for correct
cycle times, or to change if desired. However, only
trained technicians should change the time set-
tings.
FILL
Press and hold the SELECT button until the dis-
play shows "000- -", then press the SELECT but-
ton once to display the Fill time screen.
This setting should stay at the 6:00 minute fill
time.
Using the UP or DOWN buttons, adjust the back-
wash time from 0 minutes to 60 minutes.
ADJUSTABLE FAST RINSE
Press and hold the SELECT button until the dis-
play shows "000- -", then press the SELECT but-
ton four times to advance to the Fast Rinse time
adjust screen.
I_!I_I !_!
I I
0
t ! O
[ TIME
Using the UP or DOWN buttons, adjust the fast
rinse time from 0 minutes to 60 minutes.
ADJUSTABLE BRINE DRAW
Press and hold the SELECT button until the dis-
play shows "000- -", then press the SELECT but-
ton twice to advance to the Brine Draw time adjust
screen.
Using the UP or DOWN buttons, adjust the brine
draw time from 0 minutes to 255 minutes.
ADJUSTABLE BACKWASH
Press and hold the SELECT button until the dis-
play shows "000- -", then press the SELECT but-
ton three times to advance to the Backwash time
adjust screen.
i'ltltl
UU U " "
I__'!
II--
TIME
2-2
TIMER "POWER- OUTAGE MEMORY"
If electrical power to the timer is interrupted, the
"memory" built into timer circuitry keeps time for
6 hours (nlinilnum) or more. The display is blank
and the filter will not regenerate. When electrical
power comes on, one of two things will happen.
1. The present time of day will show steady,
meaning the timer has not lost time.
2.
The display will show a time, but it will be
flashing. The timer memory did not keep the
time setting and must be reset (page 1-3). If
you do not reset the time, regenerations will
most likely be at the wrong time of day.
NOTE: The flashing display is to remind you to
reset the timer.
NOTE: If the filter was in a recharge when power
was lost, it will now finish the cycle.
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line