Kenmore 665.15522 Dishwasher User Manual


 
You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFE
If your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the Cycle Control knob can cause the covered
Detergent Dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4. Close the door firmly until it latches. The dishwasher starts a
new cycle.
You can add an item anytime before the main wash starts, or the
Cycle Control knob reaches Light Wash/Water Miser.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
You can customize your cycles by pressing an option. If you
change your mind, press RESET to turn the option off. Select a
different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Hi Temp Wash
Select this option to heat the water to 140°F (60°C) during parts
of the cycle. Heating the water helps improve washing results.
This option adds both heat and wash time to parts of the cycle.
Hi Temp Wash is useful when loads contain baked-on food.
@
NOTE: Pots Pans automatically uses this option. Hi Temp Wash
is an option with the Normal Wash, Water Miser and Light Wash
cycles.
Air Dry
Select this energy-saving option to dry without heat. Air drying is
useful when loads contain plastic dinnerware that may be
sensitive to high temperatures.
The dishes take longer to dry and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.
NOTE: Quick Rinse and Light Wash automatically use this option.
Air Dry is an option with all other cycles.
Reset
Select Reset to change an option anytime before the selected
option begins.
@
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours.
You can delay the start of a cycle up to 6 hours.
To delay the start
1. Close the door.
2. Select a wash cycle and options.
Press the desired cycle. Turn the Cycle Control knob
clockwise to the number of hours you want the dishwasher to
delay the start.
The dishwasher starts the cycle in the selected number of
hours. You can add items while the time is counting down.
3. Close and latch the door. The Cycle Control knob will not
advance if the door is unlatched.
NOTE: Quick Rinse, Water Miser and Light Wash cycles cannot
be delayed.
Heating
HEATING glows, and the cycle progression pauses, whenever
water is heated during a cycle. Wash or rinse action continues as
the water heats.
HEATING
13