Kenmore 362.72221 Range User Manual


 
Propercareandcleaningareimportantsoyourrangewill
giveyouefficientandsatisfactoryserviceFollowthese
directionscarefullyincaringforitto helpassuresafeand
propermaintenance
BE SURE ELECTRICAL POWER IS DISCONNECTED
BEFORE CLEANING ANY PART OF YOUR RANGE,
Sealed Burner Assemblies
(on some models)
CAUTION: Do NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS AND DRIP
PANS (IF SO EQUIPPED) IN PLACE,
Grate
O
Burner cap
Burner head
Drip pan
(on some models)
Electrode
Turn all the controls off before removing burner parts
and drip pans (if so equipped),
The burner grates, caps, heads and drip pans
(if so equipped) can be lifted off, making them easy
to clean..
The electrode of Si/ _ _ ',\
the spark igniter is Electrode
exposed when the \ \\
burner head is
removed. When one burner is turned to LITE, all the
burners spark. Do not attempt to disassemble or
clean around any burner while another burner is on
An electric shock may result, which could cause you
to knock over hot cookware+
Burner Heads
(on sealed burners only)
NOTE: Before removing the burner heads and caps,
remember their size and location+ Replace them in the
same location after cleaning+
For proper ignition, make
sure the sma]l hole in the
section that fits over the
electrode is kept open.
A sewing needle or wire
twist-tie works well to
unclog it+
The slits in the burner heads of your range
must be kept clean at all times for an even,
unhampered flame.
You should clean the surface burners routinely, especially
after bad spillovers, which could clog these openings.
To remove burned-on food, soak the burner heads in
a solution of mild liquid detergent and hot water for 20-30
minute& For more stubborn stains, use a toothbrush+
Before putting the burner head back, shake out excess
water and then dry it thoroughly by setting it in a warm
oven for 30 minutes°
Replace the burner heads
and caps. Make sure that
the heads and caps are
replaced in the correct
location+ There is one
small, 2 medium and one
large cap.
NOTE: On some models
the burner heads and caps
are all the same size and
can be used in any of the
4 needed locations°
8
After cleaning, make
sure the slot in the
burner head is
positioned over the
electrode
NOTE: Do not use steel wool or scouring powders to
clean the burners.
(continued next page)
21