Kenmore 362.72221 Range User Manual


 
PREPARATION
Remove all tape and packaging_ Lift up the cooktop
(on models with standard twin burners) and remove
any packing material under it. Make sure the standard
twin burners are properly seated and level.
Remove plastic film that covers some chrome parts
(around oven door, side trim).
Take the accessory pack out of the oven.
o Check to be sure that no range parts have come loose
during shipping.
STEP 1
Provide Adequate Gas Supply
Your range is designed to operate at a pressure of
4" (10.2 cm) of water column on natural gas or, if
designed for LP gas (propane or butane), 10" (25.4 cm)
of water column.. Make sure you are supplying your
range with the type of gas for which it is designed.
This range is convertible for use on natural or propane
gas.. If you decide to use this range on LP gas,
conversion must be made by a qualified LP installer
before attempting to operate the range on that gas°
For proper operation, the pressure of natural gas
supplied to the regulator must be between 4" (10o2 cm)
and 13" (33 cm) of water column. For LP gas, the
pressure supplied must be between 10" (25.4 cm) and
!3" (33 cm) of water column.. When checking for proper
operation of the regulator, the inlet pressure must be at
least 1" (2.5 cm) greater than the operating (manifold)
pressure as given above. The pressure regulator located
at the inlet of the range manifold must remain in the
supply line regardless of whether natural or LP gas is
being used° A flexible metal appliance connector used
to connect the range to the gas supply line should have
an I.D of 1/2" and be 5 feet (1..5 m) in length for ease
of installation_ In Canada, flexible connectors must be
single wall metal connectors no longer than 6 feet
(1.8 m)in length.
STEP 2
Connect the Range to Gas
Shut off the main gas supply valve before disconnecting
the old range and leave it off until new hook-up has
been completed., Don't forget to relight the pilot on other
gas appliances when you turn the gas back on,,
Because hard piping restricts movement of the range,
the use of an A..G_A.-certified flexible metal appliance
connector is recommended unless local codes require
a hard-piped connection. Never use an old connector
when installing a new range.. If the hard piping method
is used, you must carefully align the pipe; the range
cannot be moved after the connection is made.
To prevent gas leaks, use pipe joint compound
or wrap Teflon* pipe thread tape around all male
(external) pipe threads.
*Teflon: Registered trademark of DuPont
Gas Pipe and Electric Outlet Locations for
Models Equipped with Sealed Burners
This area aitows
for flush range
installation with
through-the-wall
connection of pipe
stub/shut-off
valve and rear
wall 120V OUflet.r
Shortest
connection from
hard pipe stub
location to
range hookup.
I connection of pipe
I
stub/shut-off valve, r
32