Filter
Top Products
Before Using the Cooktop
Use Quality Cookware in Good
Condition
The cookware used with the Unduction
Cooktop shouUdhave flat bottoms that
make good contact with the entire surface
of the Cooking Zone, Check for flatness by
rotating a ruUeracross the bottom of the
cookware (See Fig, 21), Be sure to follow
aHthe recommendations for using
cookware as shown in Fig, 20,
Also remember to:
, Use cookware made with the correct
materiaUtype for Unduction Cooking (See
Fig, 18),
, Use quality cookware with heavier
bottoms for better heat distribution
allowing for more even cooking results,
, The pan size should match the amount
of food being prepared,
, Do not Jetpans boit dry. This may cause
permanent damage inthe form of breakage,
fusion, or marring that can affect the
ceramic cooktop, (This type of damage is
not covered byyour warranty),
o Do not use dirty pans with grease
buildup, Always use pans that are easy
to clean after cooking,
Fig. 21
The Cooking Zones may
appear to be cool while turned ON and after
they have been turned OFF, The gJass
surface may be HOT from residual heat
transfered from the cookware and burns
may occur,
DO NOT TOUCH HOT
COOKWARE or PANS directly with
hands. Always use oven mitts or pot
holders to protect hands from burns,
DO NOT SLIDE Cookware
across the cooktop surface. Doing so
may permanently damage the appearance
Induction Cookware Recommendations
fNCORRECT
o Cookware not centered on Cook-
ing Zone surface,
o Cuwed or warped pan bottoms or
sides,
I
I_ Min. size _J
o Pan does not meet the minimum
size required for the Cooking Zone
used (See Fig, 19),
o Pan bottom rests on cooktop trim
or does not rest completely on the
cooktop surface,
o Heavy handle tilts pan,
CORRECT
o Cookware centered correctly on
Cooking Zone surface,
o Flat pan bottom & straight sides,
w
I_ Min. size _1
o Pan size meets or exceeds the
recommended minimum size for
the Cooking Zone (See Fig, 19),
w
o Pan rests completely on the
Cooktop surface,
o Pan is properly balanced,
Fig, 20
PLEASE NOTE - ANY one of the incorrect conditions Hsted above in
Fig. 20 may be detected by the sensors Jocated beJow the ceramic
cooktop surface, ff the cookware does not meet any of these
conditions, one or more of the Cooking Zones will not heat indicated
by an F in the affected Cooking Zone display. Correct the problems
before attempting to activate the cooktop.