Filter
Top Products
ENGLISH
9
Setting Surface Controls (cont’d)
Models with Ceramic Glass Cooktop (cont’d)
Surface Cooking Settings
Use the chart (Figure 1) to determine the correct setting for the kind of food you are
preparing. The Simmer settings are used to simmer and keep larger quantities of foods
warm such as stews and soups. The lower Simmer settings are ideal for delicate foods
and melting chocolate or butter.
Note: The size and type of cookware used will influence the setting needed for best
cooking results.
Figure 3
Figure 2
Right Rear, Left Rear and Left
Front Elements
Recommended Settings for Single and
Dual Surface Elements
Setting Type of Cooking
HIGH (Hi) Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (5-8) Continue a rapid boil, fry, deep fat fry
MEDIUM (5) Maintain a slow boil, thicken sauces and gravies, steam
vegetables
MEDIUM LOW (2 - 4) Keep foods cooking, poach, stew
LOW (Lo - 2) Keep warm, melt, simmer
Figure 1
Radiant
surface elements may
appear to have cooled after
they have been turned off. A
hot surface indicator light
will come on and will
continue to glow until the
glass cooktop has cooled
down to a moderate level.
The glass surface may
still be hot and burns may
occur if the glass surface is
touched before the indicator
light has turned off.
Do not place
plastic items such as salt
and pepper shakers,
spoon holders or plastic
wrappings on top of the
range when it is in use.
These items could melt or
ignite. Potholders, towels or
wooden spoons could catch
fire if placed too close to the
surface elements.
Operating Single Radiant Surface Elements
The cooktop has single radiant surface elements at 3 locations; the right rear, left rear and
left front (Figure 2) element positions.
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the desired setting
(Figure 3). Turn the knob to adjust the setting if desired. Start most cooking
operations on a higher setting and then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat at each setting. A glowing red
surface heating area extending beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
3. When cooking has completed, turn the surface control knob to OFF before removing
the cookware. Note: The Hot Surface Indicator light will come on when the control
knob is turned on and will continue to glow until the glass cooktop has cooled down to
a moderate level. The light may remain on even though the controls are turned OFF.
Note: See above, Figure 1 for recommended control settings.