7
Before setting oven controls
Oven vent location
The oven vent is located under the left side of the control panel
(Figure 1). When the oven is on, warm air passes through this
vent. This venting is necessary for proper air circulation in the
oven and good baking results. Steam or moisture may appear
near the oven vent, this is normal. Do not block oven vent:
Always use pot holders or oven mitts when using
the oven. When cooking, the oven interior and exterior and oven
racks will become very hot which can cause burns.
Protective Liners — Do not use aluminum foil to
line the oven bottom. Only use aluminum foil as recommended
in this manual. Improper installation of these liners may result in
risk of electric shock, or fire
Removing, arranging and replacing racks
Arranging - always arrange the oven racks when the oven is
cool.
To remove - pull the rack forward until it stops. Lift up front of
rack and slide out.
To replace - fit oven rack onto the rack guides on both sides of
oven walls. Tilt the front of oven rack upward and slide the rack
back into place. Be sure oven racks are level before using.
Type of oven racks
The flat oven rack (some models) or flat handle oven rack (some
models) may be used for most cooking needs.
The offset oven rack (on some models) is designed to place the
base of the rack about 1/2 of a rack position lower than flat
oven racks. This design allows several additional positions
between the flat rack positions.
To maximize oven cooking space place the bottom oven rack
(on some models) in the lowest rack position for roasting large
cuts of meat.
Air circulation in the oven
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or back
of the oven cavity. Hot air must be able to circulate around the
cookware in the oven for even heat to reach around the food.
Figure 1:
oven vent
location
Figure 2:
at oven rack
bottom oven
rack
at handle
oven rack
oset
oven rack