Filter
Top Products
Setting Oven Controls
f-
• ®
!i Gok
Tm_
• • • CJ'dE_
I'imel /:)÷l{_ y • PR_HEA/"
s_,/o_fiii _,_.
® ®
®
Seect
CleGn
OVEH
OC_O_,T
Note: The time of daY must first be set in order to Operate the oven:
To Set the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash
"12:00".
1. Press _ once (do not hold pad down).
2. Within 5 seconds, press and hold the _ or V until the correct time of day appears in the display.
Note: The clock cannot be changed during any timed bake or Self-Clean cycle.
To Set the Minute Timer:
1. Press 'se_{;_.
2. Press the A to increase the time in one minute increments. Press and hold the J_%to increase the time in 10 minute
.
4.
increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If the %£i pad is pressed first, the timer will advance to 11 hours and 59 minutes.
The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in seconds.
When the set time has run out, the timer will beep 3 times, it will then continue to beep 3 times every 60 seconds until
{_,_is pressed.
Note: The indicator light located above the pad will glow while the minute timer is active.
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is
in use with any other function, the minute timer will be shown in the display. To view other functions, press the pad for that
function.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press and hold the _,,_ or _ to increase or decrease the time.
To Cancel the Minute Timer before the set time has run out: Press s_t .
Note: Toturn the time of day display OFF Or ON in the d splay pr _onds(the control will beep
once) and then release: This feature does not remove the set time of day from the memory of the control When the display
s tUlned OFF the iime oi day w seconds ani rims the @ pad st oic_e&