Filter
Top Products
BASE GRILLE INSTALLATION
To remove the base grllle:
1) Open the Freezer Drawer. (Drawer not shown for
clarity.)
2) Once the drawer is open, and there is sufflcient
clearance, remove the screws on the top of
the cover.
To replace the base grllle:
Place the cover into position and then insert and
tighten the screws.
INSTALLATION (continued)
lo
To avoid noise and vibration, the unit must be leveled
and installed on a solidly constructed floor. If required,
adjust the leveling legs to compensate for unevenness
of the floor. The front should be slightly higher than
the rear to aid in door closing. Leveling legs can be
turned easily by tipping the cabinet slightly. Turn the
leveling legs left to raise the unit or right to lower it.
(See LEVELING AND DOOR ALIGNMENT.)
NOTE: installing on carpeting, soft tile surfaces,
a platform or weakly supported structure is not
recommended.
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off all
dust that accumulated during shipping.
2. Instatt accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are packed
together to prevent possible damage during shipment.
3. Allow your refrigerator to run for at least two to three
hours before putting food in it. Check the flow of
cold air in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.
o
install this appliance in an area where the temperature
is between 55°F (13°C) and 110°F (43°C). If the
temperature around the appliance is too low or high,
cooling ability may be adversely affected.
3. Select a place where a water supply can be easily
connected for the automatic icemaken
NOTE: The water pressure must be between 20 and
125 psi on models without a water filter and between
40 and 125 psi on models with a water filter.
o
Too small of a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at least 24
inches (61 cm) in front of the refrigerator to open the
doors.
INSTALLATION
The refrigerator should always be plugged into its own
individual properly grounded electrical outlet rated for
115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes.
This provides the best performance and also prevents
overloading house wiring circuits which could cause a fire
hazard from overheated wires. It is recommended that a
separate circuit serving only this appliance be provided.
Shock Hazard:
To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
10