Filter
Top Products
I
I
[iiiiiiit'--_
÷
CAREANDCLEANING
RemovableParts(cont.)
CLEANING MATERIALS
• Dishwashing detergent
• Warm water
• Scouring pad or soap-filled
steel-wool pad
Bump
In
Rack
Rekmd Guide
Back of
the Rack
TO REMOVE
1. Pullthe racks out to the stop
position.
2. Pull up the front of the rack and
slide under the bump of the rack
guide.
TO CLEAN
Clean with warm water and detergent
For hard-to-remove stains, gently
scrub with a scouring pad or a
sosp-filled steel-wool pad. Rinse well,
TO REPLACE
1. Place the raised back of the rack
onto the rack guides,
2. Lift the front of the rack untilthe
raised back slides under the bump
of the rack guides.
3. Slide the rack all the way back.
TO REMOVE
1. Fullyopen the
door.
2. Push the hinge
locks down
toward the door
frame, to the Slot
unlocked
position. This
may require a
flat-blade
screwdriver.
Hinge Lock
(Unlock_l
PoJtton)
Arm
3. Firmly grasp both
sides of the door
at the top.
4. Close door tothe
door removal
position,
5. Lift door up until
the hinge arm is
clear of the slot.
RemovalPooltlon
TO REPLACE
1.
2,
Bottom Hinge
Firmly grasp both Edge of Arm
sides of the door
at the top
With the door at
the same angle
as the removal
position, seat the
indentation of the
hinge arm into
the bottom edge of
the hinge slot. Indoctatlon
÷
26
m
I '6 ÷ I