Filter
Top Products
8
troubleshooting guide
P
roblem Cause Solution
The processor will not operate. No Power. Check processor is plugged in.
Bowl not fitted to power unit correctly. Check bowl is located correctly and
the handle is situated towards the
r
ight hand side.
Bowl lid not locked on correctly. Check that the lid interlock is
l
ocated correctly into the handle
area.
T
he processor will not work
i
f the bowl and lid are fitted
i
ncorrectly.
If none of the above check the
fuse/circuit breaker in your home.
Liquidiser or mini chopper/mill will not operate Liquidiser or mini chopper/mill not locked The liquidiser or mini chopper/mill will
on correctly. not operate if fitted incorrectly to the
interlock.
Liquidiser or mini chopper/mill not assembled Check blade unit is fully tightened
correctly. into the goblet/jar.
Processor stops during Processor overloaded/maximum capacities Check maximum capacities stated
processing exceeded. in the recommended speed chart.
Lid unlocked. Check lid is locked correctly.
Liquidiser or mini chopper/mill leaking from Seal missing Check seal is fitted correctly and not
blade assembly base. Seal incorrectly fitted damaged. To obtain a replacement
Seal damaged. seal see “service & customer care”
Poor performance of tools/attachments Refer to hints in relevant “using the attachment” section. Check attachments are
assembled correctly.