Filter
Top Products
SAVE THESE INSTRUCTIONS
WARNING
Instructions pertaining to a risk of fire, electric shock, or injury to persons.
Electrical Instructions:
An electrical supply of 220-240 volts AC only, 50Hz is required. Make sure that a suitable
electrical supply socket is located close to where the dishwasher is to be placed.
For your
personal safety, the appliance must be earthed. The appliance is equipped with a power
supply cord having a 3-pin plug. To minimize possible shock hazards it must be plugged into a
matching 3-pin type electrical outlet.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other
reason, then the cut off plug should be disposed of safety to prevent the hazard of electric shock.
Installation Instructions
1. Remove all packing materials carefully
2. Use the supplied hose. Do not reuse old hoses.
3. The water inlet hose from the machine terminates in a ¾” female connector. The water
supply should therefore terminate in a similar male connector and should have a
stopcock close by in the pipe. It is recommended to connect the machine to hot water
supply. Connect the straight connector of the inlet hose to the water supply securely.
Connect the other end (bent connector) to the water inlet valve at the back of the
dishwasher cabinet. Do not over-tighten to avoid damage to threads.
4. Prepare the drainage hose so that it has hooked end. Use the plastic U-bend fitting
provided for this purpose. The end of this should be dropped into a drainage standpipe,
the maximum height of which should be no more than 6” above the base of the
dishwasher. To allow for an air gap around the end of the drain hose, the diameter of the
standpipe should be at least 30 mm. Connect the other end of the drain hose (L shaped)
to the drain port connection at the back of the dishwasher cabinet. Tighten the drain hose
end on to the drain port using the metal clip included in the package.
5. If you so wish, you may connect the water inlet hose on to the kitchen sink tap. You must
obtain correct fittings/adaptors to match the inlet hose connectors to ensure secure
connection. However, permanent plumbing is recommended.
6. If leaks are located, immediately shut the water supply and check the hose connections
fully. Tighten connections if necessary.
7. If for any reason you are unable to stop the leak yourself please seek advice from a
qualified plumber.
8. The minimum height clearance required to install your dishwasher on a countertop
surface with overhead cupboards is 19” (48cm).
9. Make sure there is an electrical power supply within easy reach of the machine. The
power cord is 210cm long.
10. The dishwasher must be installed on a ‘firm’ level surface.
11. To level the dishwasher, adjust the 4 level screws (feet) under the dishwasher.
Water Pressure
For best operating results, incoming water pressure should be between 0.03~1Mpa.
Incoming water supply for the dishwasher is controlled by a ‘low water switch’ application, so
if household water closedown, dishwasher will stop.
3