Filter
Top Products
to fit and use your pouring shield
1 Raise the mixer head until it locks.
2 Fit the bowl and the desired tool.
3 Slide the narrow section of the pouring shield under the mixer
attachment ᕨ.
4 Fit the pouring shield onto the bowl.
5 Turn the pouring shield until the narrow section of the shield
aligns with the groove on the tool socket ᕩ.
6 Lower the mixer head.
7 Turn the opening of the pouring shield to the desired position.
8 Fit the chute onto the pouring shield by locating the tabs in
the slots µ.
9 To remove the pouring shield reverse the operation.
●
During mixing, ingredients can be added directly to the bowl via
the chute.
6
ᕨ
ᕩ
µ
cleaning and service
care and cleaning
●
Always switch off and unplug before cleaning.
power unit
●
Wipe with a damp cloth, then dry.
●
Never use abrasives or immerse in water.
bowl, tools,
pouring shield
●
Wash by hand, then dry thoroughly or wash in the dishwasher.
●
Never use a wire brush, steel wool or bleach to clean your
stainless steel bowl. Use vinegar to remove limescale.
●
Keep away from heat (cooker tops, ovens, microwaves).
flexible beater
●
Always remove the flexible wiper blade from the tool before
cleaning ¸.
●
Wash the flexible wiper blade and tool in hot soapy water, then dry
thoroughly. Alternatively the parts can be washed in a dishwasher.
Note: Please inspect the condition of the tool body before and after
use and also regularly inspect the condition of the wiper blade and
replace it if there are any signs of wear.
¸