Kenwood RC400 Rice Cooker User Manual


 
before using your Kenwood
appliance
Read these instructions carefully and
retain for future reference.
Remove all packaging and any
labels.
safety
Never put the body of the appliance
in water or let the cord or plug get
wet – you could get an electric
shock. And never put liquid in the
body of the appliance.
Never use a damaged appliance.
Get it checked or repaired: see
‘service’.
Keep children away from the
appliance. And never let the cord
hang down where a child could grab
it.
Don’t get burnt by hot parts, boiling
water or steam from the appliance.
Use oven gloves when removing the
inner bowl and lid.
Do not keep rice warm for longer
than one hour and do not reheat
cooked rice in the rice cooker.
Don’t let the cord touch hot parts.
Unplug when not in use and never
leave the appliance on unattended.
Don’t place on or near a hot gas or
electric burner or in a heated oven.
Don’t leave the appliance on a heat
sensitive surface.
Only use the rice cooker with the
inner bowl supplied.
Don’t use the appliance outdoors.
Do not let infirm people use the
appliance without supervision.
Do not let children use or play with
the appliance.
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your rice cooker.
This rice cooker complies with
European Economic Community
Directive 89/336/EEC.
Important – UK only
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
The appliance must be protected by
a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
before using for the first time
Wash the parts see ‘cleaning’.
2