Filter
Top Products
3
Installation
FOR RESIDENTIAL USE ONLY
NOT TO BE INSTALLED OVER GAS GRILLS
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL CODES.
IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use.
INSTALLER: Please leave these Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
SAFETY WARNING: Turn off power circuit at the service entrance and lock out
panel, before wiring this appliance.
Requirement: 120 V AC, 60 Hz. 15 or 20 A
Weight: 31,3 lbs
Diameter of Transition: 6”
Diameter of exhaust Duct required: 6”
Dimensions
Considerations before installing Hood
1. For the most efficient air flow exhaust, use a straight run or as few elbows
as possible.
CAUTION: Vent unit to outside of building, only.
2. If allowed in your area, use metallic flex ducting only to connect rigid duct
directly to transitions.
3. COLD WEATHER installations should have an additional backdraft damper
installed to minimize backward cold air flow and a nonmetallic thermal
break to minimize conduction of outside temperatures as part of the
ductwork. The damper should be on the cold air side of the thermal break.
The break should be as close as possible to where the ducting enters the
heated portion of the house.
4. Hood installation height above cooktop is the users preference. The lower the
hood above the cooktop, the more efficient the capturing of cooking odors, grease
and smoke. We recommend the hood be installed 30-36" above the countertop.
The lower height may be inconvenient for tall people and large cooking vessels.
Check your ceiling height and the maximum hood height before you select your
hood.
5. The hood can also be used with a filtering function by fitting one part
B80011 Kenyon activated charcoal filter. The air is filtered and recirculated
through the upper grid located on both sides of the lower section of the cover. This
function is the best solution when is not possible to exhaust air to the outside.
A Conversion Kit must be ordered separately to equip the cooker hood for
filtering.
This special kit contains a filtering duct (to be mounted in place of the
transition) and a charcoal filter (for filtering cooking odors).
Figure 1*
Note: All dimensions are shown in
inches.
* Dimensions are given from
base of hood to ceiling, and
include clearance required for
installation.
Dimensions
A (Range of adjustable ht.)* 35
1
/
2
- 41
3
/
4
B (Min. ht. with one cover)* 27
3
/
4
W (width) x D (depth) 8
3
/
16
x 6
7
/
8
AA (Cover adjustable ht.) 23
7
/
16
- 32
15
/
16
BB (Cover min. height) 16
W
D
20
1/4
"
30" - 36
15 3/16"
B
A
AA
BB