Filter
Top Products
5
Installation
Appliance Installation:
11. Install transition on top of hood if removed for shipping. Mark onto exterior of
transition the ‘V’ location of the damper within. Figure 4.
Note: Duct screws can ONLY GO BELOW this line.
For Filtering Function ONLY:
Install filtering duct on top of hood instead of transition. Filtering duct is
available only by ordering the conversion kit for filtering function.
Kenyon Part # B80011
12. Hang hood on 2 mounting hooks through the rectangular cutouts on back of
hood. Figure 5
13. Level the appliance, using a carpenters level across bottom of hood with
leveling screws in mounting hooks or rectangular cutouts.
14. Secure hood with 2 screws on top and 2 screws on bottom. See Figure 5.
15. Connect ducting (Figure 4).
Note: for blower serviceability, leave a gap of 1" minimum between top
of transition and sheet metal duct and cover gap with a starting collar
wrapped around duct and transition. Locate collar screws so they fit into
corner of duct cover. Secure collar to transition and duct with three sheet
metal screws each. Seal with duct tape.
Do not use duct smaller than the transition.
Starting
Collar
1"
Figure 4
Figure 5
Filtering
duct