Filter
Top Products
7
Ready to Brew your First Cup
1. The green light next to the Power Button on
the LED Control Center will be illuminated
to indicate the Brewer is powered on.
2. Place a cup or mug on the Drip Tray Plate.
3. Lift the Handle and the K-Cup
®
Holder will
open toward you.
4. Select a K-Cup
®
portion pack.
5. Place a K-Cup
®
portion pack in the K-Cup
Holder (as shown in exhibit at top of page).
6. Lower the Handle completely to close the
Lid.
7. Select the brew size you want using the
rotary selector switch.
8. Press the flashing blue Brew Button on the
LED Control Center. This will yield a serv-
ing of the selected size; small 6 oz. medium
8 oz. and large 10 oz. nominal sizes.
9. The blue Brew Button on the LED Control
Center will be on while brewing.
10.There may be a short pause before the brew-
ing process begins. The entire brew process
lasts for approximately 40 to 50 seconds
and ends with a burst of air to remove all
liquid coffee or tea from the K-Cup
®
. The
blue Brew Button will go off.
11.Lift the Handle to remove and dispose of
the used K-Cup
®
. CAUTION: K-Cup
®
will
be hot.
12.Enjoy your first cup of Keurig Brewed
®
gourmet coffee or tea!
13. The red light next to 'HEATING' on the
LED Control Center may light as the water
is heated for the next brew cycle. The
Brewer will be ready for use in approxi-
mately 20 seconds.
Stopping the Brew Process
If you need to stop the brewing after the
process has started, press the Power Button
to turn the Brewer ‘OFF’. The flow of coffee or
tea will stop, the heating element will shut off
and the green light next to the Power Button
will extinguish.
NOTE: Do not remove the foil lid or
puncture the K-Cup
®
portion pack.
CAUTION: There are two sharp needles that
puncture the K-Cup
®
portion pack, one above
the K-Cup Holder and the other in the bottom
of the K-Cup Holder.
T
o avoid risk of injury,
do not put your fingers in the K-Cup Chamber.
NOTE: If you do not push the flashing Brew
Button in 60 seconds, the Brew Button will
be disabled to prevent accidental activation.
Re-activate the Brew Button by raising and
lowering the Handle completely, without
removing the unused K-Cup
®
.
CAUTION: There is extremely hot water in
the K-Cup Holder during the brew process.
T
o avoid risk of injury, do not lift the
Handle or open the K-Cup
®
Chamber
during the brew process.
Handle
K-Cup
Chamber
NOTE: Following the brew, your Brewer will
fill in preparation for the next brew. The pump
will make a vibrating sound. This is normal.
K-Cup
®
portion pack
ADD WATER
DE-SCALE
HEATING
AUTO-OFF
POWER
DRAIN BREWER
PUSH TO BREW
BREW
NOTE: You may get less coffee or tea in your
cup during your next brew. We recommend
that you perform a cleansing brew without a K-
Cup
®
after a terminated brew or when a prime
sequence has been completed. Then your
NEXT brew will be the proper selected volume.