Filter
Top Products
6
Installation Clearances
Cabinet opening dimensions shown are for 25" (64 cm) countertop depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm)
countertop height.
Freestanding Ranges Slide-In Ranges
NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet is protected by not less than ¹⁄₄" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.
If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the cooktop surface.
A.18" (45.7 cm) upper cabinet to countertop
B.13" (33 cm) upper cabinet depth
C.30" (76.2 cm) min. opening width
D.For minimum clearance to top of the cooktop, see NOTE.
E.30" (76.2 cm) min. opening width
F. This shaded area recommended for installation of rigid gas pipe.
G.6" (15.2 cm) available area for gas and electric installation
H.Grounded outlet
I.7" (17.8 cm)
J.1¹⁄₂" (3.8 cm)
K.4¹⁄₂" (11.4 cm)
L.5" (12.7 cm) min. clearance from both sides of the range to the
side wall or other combustible material.
M.Cabinet door or hinge should not extend into the cutout.
M
A.18" (45.7 cm) upper cabinet to countertop
B.13" (33 cm) max. upper cabinet depth
C.30" (76.2 cm) min. opening width
D.For minimum clearance to top of the cooktop, see NOTE.
E.30" (76.2 cm) min. opening width
F. This shaded area recommended for installation of rigid gas pipe.
G.6" (15.2 cm) available area for gas and electric installation
H.Grounded outlet
I.7" (17.8 cm)
J.1¹⁄₂" (3.8 cm)
K.4¹⁄₂" (11.4 cm)
L.5" (12.7 cm) min. clearance from both sides of the range to the
side wall or other combustible material for models KGSS907 and
KGRS807.
2" (5.1 cm) min. clearance for model KGSK901
M.22
¹⁵⁄₁₆
" (58.3 cm) opening depth
N.¾" (1.9 cm) radius both corners
O.Cabinet door or hinge should not extend into the cutout.
M
N
O