Filter
Top Products
Now start .
n n n
El
1
Place cardboard or other form of
. protection on top of a flat surface where
you can easily assemble the downdraft
vent system. Remove downdraft blower box and
motor section from cartons. Remove any
shipping materials, tape and protective film from
downdraft blower box and motor. Remove parts
package from inside blower box opening.
Remove capacitor from motor.
cl
2
Determine which direction (right or left)
g
the blower box with
motor attached will
need to be installed.
(two on each side)
that attach the
\’
1 if-f
wiring box to the blower box. Place screws and
wiring box in a safe place.
cover to blower box
‘V
so that the control end
will be at the front of the cutout.
El
5
Use a Phillips
screwdriver to
n
remove the
screws that
attach the legs to the
blower box. Place the
slotted area of legs over
the area where the screw openings are located.
Replace the screws but Do Not tighten screws.
Excessive Weight Hazard
Use two or more people to move and install
downdraft vent.
Failure to follow this instruction can result
in back or other injury.
0
8
Determine which direction (right, left or
n
down) the ductwork will run from the
blower duct when installed in the
cabinet. Place the motor on the blower box so
that the duct opening is in the position you need
to complete the ductwork. Do Not tighten screws.
Measure location of
blower motor duct.
6” blower motor I
exhaust duct \
I4 *
1
-
ITT
-
leg-mounting hole
/ I
Transfer measurements and cut duct
opening in cabinet floor or wall
dependmg on your installation.
Cut opening
/ \
191
. Determine center of blower motor duct in
relation to one leg-mounting hole. Use
this measurement to locate center of blower
motor duct cutout. Cut 6-inch duct opening.
13