Filter
Top Products
5
Assembling Your 5 Quart Tilt-Head Mixer
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Place bowl on bowl lock plate.
6. Turn bowl gently in clockwise
direction.
7. Lower motor head and lock.
8. Plug into a grounded 3 prong
outlet.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Turn bowl in counterclockwise
direction and remove.
6. Lower motor head and lock.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Slip beater
onto beater
shaft and
press upward
as far as
possible.
6. Hook beater over pin on shaft by
turning clockwise (right).
7. Unlock motor head and lower.
8. Lock motor head and plug into a
grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip
or Dough Hook
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Press beater upward as far as
possible and turn counterclockwise
(left) to unhook.
6. Pull beater from beater shaft.
7. Unlock motor head and lower.
To Lock Motor Head
1. Push locking lever back as far as
possible.
2. Test lock by attempting to raise or
lower head.
NOTE: Motor head should always be
locked when using mixer, and when
attaching or removing the bowl, flat
beater, wire whip, or dough hook.
When in locked position, lever may
not extend all the way back. This is
normal.
To Unlock Motor Head
1. Pull locking lever forward as far as
possible. Motor head can now be
raised or lowered.
C
A
U
T
I
O
N
:
U
n
p
l
u
g
b
e
f
o
r
e
i
n
s
e
r
t
i
n
g
o
f
r
e
m
o
v
i
n
g
p
a
r
t
s
O
ff/O
2
4
6
8
1
0
Stir
R
e
s
e
t
ON
OFF
PIN