Filter
Top Products
6
Assembling Your 5 Quart Tilt-Head Mixer
To Attach Pouring Shield
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect
power.
3. Attach bowl along with flat beater,
dough hook, or wire whip. Lower
and lock motor head.
4. From the front of the mixer, slide
the pouring shield over the bowl
until the shield is centered. The
bottom rim of the shield should fit
within the bowl.
To Use Pouring Shield
1. For best results, rotate the shield
so the motor head covers the “u”
shaped gap in the shield. The
pouring chute will be just to the
right of the attachment hub as
you face the mixer.
2. Pour the ingredients into the bowl
through the pouring chute.
To Operate Speed Control
Plug into a grounded 3 prong outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See page 9 for Speed
Control Guide.
Overload Reset
If the mixer stops due to overload,
slide the speed control lever to
OFF. This automatically resets the
mixer. Wait a few minutes. Slide the
Speed Control Lever to the desired
speed and continue mixing. If unit
does not restart see the KitchenAid
Stand Mixer warranty on page 78.
Pouring
Chute