Filter
Top Products
3. Fasten the black plastic toe panel on the back of the custom
toe panel with the screws provided with the dishwasher.
4. Partially open bottom drawer. Position custom toe panel
behind door and slide on the underside of tub.
5. Close the drawer and slide the toe panel back onto mounting
rails.
6. If needed, you may simply push the toe panel back or forward
on the mounting rail.
7. With a Phillips screwdriver, tighten the toe panel clamping
screws on both sides.
8. Plug in dishwasher or reconnect power.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that the dishwasher is level, securely fastened to the
cabinetry and opens and closes freely with no resistance from
the cabinetry.
3. Check that the inlet hose to valve connection is tightened an
additional half turn after seal contact.
4. Check that any knockouts of plugs in the drain connection
have been drilled out and drain connection has been made.
5. Turn on the power and water supply. The dishwasher should
beep and the controls should light up.
6. Open the drawers and check the operation of the wash
program control panel.
7. Check that the spray arm is in place and rotates freely.
8. On the wash program control panel, select rinse and close the
drawers. Start the program by pressing the Start/Resume
button.
toe panel
mounting rail
clamping
screw
15
plastic
toe panel
custom
toe panel
9. After the rinse program has finished, be sure the dishwasher
has run and drained correctly.
10. Check the water supply and drainage connection for leakage.
11. Check that you have all of your tools.
12. Dispose of/recycle all packaging materials.
13. Read “Dishwasher Use” in the Drawer Dishwasher Use and
Care Guide.
If dishwasher does not operate, check the following:
■ Household fuse is intact and tight; or circuit breaker has not
tripped.
■ Electrical supply is connected.
■ See “Troubleshooting” in your Use and Care Guide.