Filter
Top Products
8
18. Use the side cutting pliers to cut the cable tie securing the
hoses and power supply cord to the back of the dishwasher.
19. Completely remove the power supply cord and save it, in
case a power cord installation is needed in the future.
20. Place cardboard or other protective covering on the floor in
front of cabinet opening. Place the dishwasher on covering.
21. Begin to route the hoses through the utility hole in the cabinet.
IMPORTANT: Push against the outside edges of drawers as
shown. Do not push against the center of the drawers.
22. Push dishwasher part way into the opening.
23. As the dishwasher is being pushed into the opening, slowly
pull the inlet hose and drain hoses through the utility hole. Let
the house wiring gather behind the dishwasher.
24. Remove the strap/tape from upper drawer.
WARNING
Tip Over Hazard
Do not use dishwasher drawer until inside cabinet
opening.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
If Installing Flexible Trim Pieces
If the cabinet opening is 24" wide x 34-1/2" high (61.0 cm x
87.6 cm), flexible trim pieces can be attached along the top and
sides of the dishwasher. Top and side trim pieces are different
lengths.
1. Open the drawers to expose the chassis trim.
2. Center the flexible trim pieces.
3. If using the optional top attaching brackets, place the trim
pieces under the attaching brackets.
4. Remove trim pieces backing paper to expose the adhesive.
5. Place the trim pieces on the trim and press.
6. Finish pushing dishwasher into opening.
Install Dishwasher
1. Leave protective cover on floor.
2. Open the bottom drawer.
3. Press in the right-hand runner clip and push it back about 6"
(15.2 cm). Repeat with the left-hand runner clip.
NOTE: When removing the drawer there is limited range of
movement due to the attached water hoses.
4. Lift the right edge of the drawer off its runner. Slide that runner
back into the dishwasher.
5. Lift the drawer completely off the left-hand runner.
6. Rotate the drawer to the right onto its side and place on the
protective cover.
chassis
trim
edge
chassis trim
edge
side trim
piece
side trim
piece
side trim
piece
open drawer
top trim
piece
lip
runner clip
back of
dishwasher
cable tie