Filter
Top Products
5
English
Assembling the Ice Cream Maker Attachment
for Bowl-Lift Mixer*
To Assemble Freeze Bowl and Dasher:
NOTE: Use the freeze bowl immediately
upon removal from the freezer, as it
begins to thaw once removed.
IMPORTANT: Do not pour ice cream
batter into the freeze bowl until all parts
are assembled and the mixer is running.
1. Turn stand mixer speed-control to “O”
(off) and unplug mixer.
2. Place bowl-lift handle in down position
and remove mixing bowl.
3. Fit the freeze bowl into place over the
locating pins.
4. Press down on the back of the freeze
bowl until the bowl pin snaps into the
spring latch.
NOTE: The freeze bowl is designed to fit all
bowl-lift mixers. If the bowl pin at the back
of the bowl is too short or too long to snap
into the spring latch, remove and rotate the
bowl so the opposite bowl pin faces the
spring latch. Repeat steps 3 and 4.
5. Place the dasher inside the freeze
bowl.
Pin too
short
Correct
pin fit
LOCATING
PIN
* For tilt-head mixer, see page 3 and 4.