Filter
Top Products
6
English
To Attach Drive Assembly:
1. Be sure the speed-control is still on “O”
(off) and the mixer is unplugged.
2. Make sure the bowl-lift handle is still in
the down position, and the freeze bowl
and dasher are in place.
3. Determine your mixer model by
checking for a spring on the beater
shaft, then position the drive assembly
as illustrated for proper placement.
4. Slide drive assembly onto the motor
head until it will not slide any further.
When properly assembled, the outer
curved edges of the drive assembly
should center on the motor head. If
they are not centered, slide the drive
assembly either back or forward until it
is centered on the motor head. Make
sure the drive assembly is securely in
place by pressing upward.
NOTE: If drive assembly will not fit onto
the motor head, try using the other side of
the drive assembly.
5. Raise the bowl to engage the dasher
with the drive assembly before mixing.
If the drive assembly doesn’t engage
the dasher, slide the drive assembly
either back or forward until it does
engage the dasher properly.
6. Plug the mixer into a grounded
3-prong outlet.
Assembling the Ice Cream Maker Attachment
for Bowl-Lift Mixer*
MOTOR
HEAD
BEATER
SHAFT
* For tilt-head mixer, see page 3 and 4.
Spring
No Step
No Spring
Step
Wider End
(marked “A”)
Narrower
End
(marked “B”)