Filter
Top Products
10
English
Care and Cleaning
The Blender pitcher, locking collar and
blade assembly can be easily cleaned as
individual components or together without
disassembly.
• Clean the Blender thoroughly after
every use
• Do not immerse the Blender base or
cord in water
• Do not use abrasive cleansers or
scouring pads
To Clean Individual Components
1. Lift the pitcher assembly in a straight,
upwards motion off the Blender base.
Place jar assembly on a hard surface.
Then, while holding locking collar,
rotate pitcher counterclockwise, two
clicks, to separate locking collar and
blade assembly, and sealing ring from
the pitcher. Wash components with
soapy water. Rinse and wipe dry.
NOTE: Pitcher can be placed in the
bottom rack of an automatic dishwasher.
For best results, hand washing is
recommended for the lid, ingredient cup,
locking collar and blade assembly, and
sealing ring.
2. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
To Clean Without Disassembly
1. Put the pitcher on the Blender base,
fill half full with warm (not hot) water,
and add 1 or 2 drops of dishwashing
liquid. Put the lid on the pitcher, press
the STIR speed setting, and run the
Blender for 5 to 10 seconds. Remove
the pitcher and empty contents. Rinse
with warm water until clean.
2. To clean the lid and ingredient cup,
wash in warm soapy water, then rinse
and dry thoroughly.
3. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
Sealing
Ring
Pitcher
Locking
Collar
and Blade
Assembly