Filter
Top Products
&tom-made
panels
Personal Injury Hazard
Handle metal edges of panels
carefully. Cut metal edges
may cause personal injury or
damage to other materials.
114”
THK.-@
r
18-
1316”*
z=----23-g” 6” -
n
1”
5116” routed top and side ed es
for panel more than l/4” thic
ii
.
*For Models: KUDA220T and
KUDA22ST-17-7/16”
**Raised door panel must have a 1”
minimum routed bottom edge to
prevent door panel from contacting the
access panel when door is opened.
Custom wood or other materials
should be l/4” thick. Thinner materials
will need to have a spacer panel
installed behind custom panel. If
custom panel is more than l/4” thick,
the outer edge will need to be routed
as shown. Custom wood panels need
a waterproof protective finish applied
to all sides and edges of panel.
Product Damage
Heavy duty door springs must
be used with custom panels
that weigh more than four
pounds.
Failure to follow this
instruction could cause
product damage.
After custom panels are installed,
check the door tension. The door
should be counterbalanced so it
doesn’t fall open or close when
opened. If the door closes from an
open position, adjust the door-
spring brackets upward to a
different hole. If door falls open too
quickly, move spring bracket
downward. If custom panels are
heavy, heavy-duty door springs are
available from your KitchenAid
dealer.
Part No. 9741159
01992 KitchenAid
Prepared by KitchenAid@, St. Joseph, Michigan
49085
Printed in U.S.A.
If the dishwasher
does not operate:
Check these points:
l
Is the door closed tightly and
latched securely?
l
Has the cycle been set correctly to
start the dishwasher?
l
Is the water turned on?
l
Has a house fuse blown or a
circuit breaker tripped?
l
Has electrical power been
interrupted?
Note: If the motor has stopped
because of overload, it will
automatically reset itself within a
few minutes.
If you need
assistance...
The KitchenAid Consumer
Assistance Center will answer any
questions about operating or
maintaining your appliances not
covered in the Installation
Instructions. The KitchenAid
Consumer Assistance Center is
open.24 hours a day, 7 days a
week. Just dial (800) 422-1230 -
the call is free.
When you call, you will need the
appliance model number and serial
number. Both numbers can be
found on the serial/rating plate
located on the front frame behind
the door.
If you need
service...
In the event that your KitchenAid
appliance should need service, call
the dealer from whom you
purchased the appliance or a
KitchenAid authorized service
company. A KitchenAid authorized
service company is listed in the
Yellow Pages of your telephone
directory under “Appliances -
Household - Major - Service or
Repair”. You can also obtain the
service company’s name and
telephone number by dialing, free,
within the continental United States,
telephone number, (800) 422-l 230.
A special operator will tell you the
name and number of your nearest
KitchenAid-authorized service
company.