Filter
Top Products
7
Assembling Your Mixer
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl lift handle in down
position.
4. Fit bowl supports over locating
pins.
5. Press down on back of bowl until
bowl pin snaps into spring latch.
6. Raise bowl before mixing.
7. Plug into a grounded 3 prong
outlet.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl lift handle in down
position
4. Remove flat beater, wire whip, or
dough hook.
5. Grasp bowl handle and lift straight
up and off locating pins.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Slip flat beater
on beater shaft
and press
upward as far
as possible.
4. Turn beater to right, hooking beater
over the pin on shaft.
5. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater, Wire Whip,
Or Dough Hook
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Press beater upward as far as
possible and turn left.
4. Pull beater from beater shaft.
5. Plug into a grounded 3 prong
outlet.
Commercial mixer SPEED Control
and Lever Guard
The Soft Start™ feature minimizes
splash-out by starting the mixer slowly
before increasing to the selected
speed. To further reduce the potential
for splash-out, always begin mixing
using the STIR speed, then gradually
move to higher speeds as needed. See
page 9 for the Speed Control Guide.
Auto-Reset Motor Protection
If the Stand Mixer stops due to
overload, slide the speed control lever
to OFF. After a few minutes, the stand
mixer will automatically reset. Slide the
Speed Control Lever to the desired
speed and continue mixing. If the unit
does not restart, see “Troubleshooting
Problems” on page 5.
OFF/0
10
2
4
6
8
STIR
RESET
RAISE
PIN
WARNING
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.