Filter
Top Products
Changing color
Custom-made
panel
panels
Depending on the model, your
compactor may have one or
more reversible color panels.
Personal Injury Hazard
. Handle metal edges of
panels carefully. Cut metal
edges may cause personal
injury or damage to other
materials.
l Replace handle before
operating compactor.
Failure to do so could result in
personal injury or damage to
other materials.
outside front .,,“.
panel
Figure 3
arawer
trim
1. Remove the drawer from the
unit (See Step 3 of the
Installation Instructions.)
2. Remove the screws that
attach the handle to the
drawer.
3. Remove one spacer panel,
4. Remove color panel(s) by
carefully pulling up.
5. Select the color you wish to
show and carefully push that
panel into the drawer trim.
6. Replace the spacer panels
and other color panel.
7. Replace the handle with the
screws removed in Step 2
above.
8. Replace the drawer. (See
Step1 1 of Installation
Instructions.)
A custom-made, l/4” (64 cm)
thick wood panel or other
suitable decorative material to
match your cabinets can be
used in place of the color
panels, Paint, wallpaper, fabric,
etc., can be applied directly to
one of the color panels (See
Figure 4.)
1. Follow steps 1 through 4 under
“Changing color panel” Also
remove all cardboard
spacers.
2. Slide decorative panel
between trim pieces.
3. Reattach handle with the
screws previously removed.
4. Replace the drawer. (See
Step 11 of Installation
Instructions.)
22-15/16”
(58.3 cm)
:y.... ,4-5,*” .--j:::
(37.2 cm)
Figure 4
Before you call
for service...
If your compactor does not
operate properly, check the
following before calling for
service -
If the compactor won’t operate:
l Is the power supply cord
securely plugged into
electrical outlet?
l Has the fuse blown or circuit
breaker tripped?
l Is the drawer completely
closed?
l Is the key-knob turned all the
way to “START” position before
it is released?
If compactor stops during
operation:
l Push drawer in firmly while
turning key-knob to start.
Repeat if necessary.
l Rearrange trash load - Do Not
load rigid items at front of
drawer.
Trash not compacted:
l Drawer must be at least l/3 full
to see compaction.
Not enough compaction or
force:
l Compacting works best when
only a few items are loaded.
Use the compacting cycle
frequently.
Bottles don’t break:
l Not all bottles will break every
time, depending upon trash
load below bottle.
Drawer won’t open:
l Drawer will open only when
ram is all the way up. To raise
the ram, push drawer in firmly
and turn key-knob to START.
Release key-knob. Open
drawer and lay cans and
bottles flat in center of drawer.
Start compactor again.
Page 5